Important Safeguards - Kalorik USK WCL 32964 Mode D'emploi

Fax +32 2 359 95 50

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should
always be followed, including the following:
After removing the wine cooler from the package, make sure it is
in good condition. In case of doubt, do not use it and contact
the customer service centre.
Plastic bags, nails, etc. should be kept out of the reach of
children
Check that your mains voltage corresponds to that stated on the
appliance.
Never leave the appliance unsupervised when in use.
Never leave the appliance unsupervised when taking beverages
out or putting them in the cooler. Keep out of reach of children or
incompetent persons.
From time to time check the cord for damages. Never use the
appliance if cord or appliance shows any signs of damage.
Never move the appliance by pulling the cord. Make sure the
cord cannot get caught in any way. Do not wind the cord
around the appliance and do not bend it. Keep the power cord
away from sources of heat.
Only use the appliance for domestic purposes and in the way
indicated in these instructions.
Should the cord be damaged, it must be replaced by a qualified
service.
Never use the appliance near hot surfaces or in the sunlight.
Never use the appliance outside and always place it in a dry
environment.
Stand the appliance on a table or flat surface in order to avoid its
fall. Ensure that there is at least a 10cm / 4 in. clearance at the
sides; and 8cm / 3 in. clearance at the back of the cooler, in
order to allow adequate ventilation. Kitchen units (cupboards)
should be at least 5cm / 2 in. away from the appliance in order to
assure adequate ventilation.
Do not place any other object on top of the appliance.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity. Print only what is inside the frame.
4
Assembly page 4/28
WCL 32964 - 111026