Belkin TunePower F8E490ea Mode D'emploi page 10

Charging the Belkin TunePower
For additional power and charging,
connect the DC plug end of the
included cable into the DC jack on
the top of the TunePower.
Connect the FireWire® end into
the AC wall charger that ships
with your iPod, or to any FireWire
port on a laptop or desktop
computer.
The LED charge indicator will illuminate when the Belkin
TunePower is charging. This indicator will turn off when
the battery has been charged to approximately 90%. To
maximize charge, leave the battery pack connected for 10
minutes after the indicator turns off. Disconnecting the
Belkin TunePower before this time, or leaving it connected
for longer periods, will not damage the TunePower.
While the iPod is connected to the TunePower, both the
iPod and the TunePower can be charged simultaneously.
After the TunePower is completely charged, the charging
cycle will continue to charge the iPod.
ea_F8E490ea.indd 7
7
Ch
App
Tun
iPo
2 h
of b
Full
If th
cha
Belk
30 s
aut
Not
whe
disc
tha
pow
The
Tun
it ta
5/10/04 2:51:4