Table des Matières
Publicité
CONNECTING IN " DIRECT MODE "
" Independent Network " or " Access Point "
When you start the SolemWF application
.
the application setup menu appears
1- Name your Module
(Visible Name in the App)
2- Select ''Setup as a Wi-Fi network''
3-
Name your irrigation network SSID
(
Visible name in the wireless settings on your smartphone / tablet)
4-
Select the type of security : "None" or "WPA2"
-
If you selected "None" send information to the product
-
If you select "WPA2", enter a password more than 8 caracters.
Press
and send informations to the product
Quit
the application, wait until the product turns green and then connect to your
Wi-Fi settings Smartphone / Tablet and select the network name chosen
in point 3 above
.
13
PROGRAMMATION
The watering program is intuitive and simple. You can create your watering
schedules. If you encounter problems, contact Solem to answer your
questions at customersupport@solem.fr
INFORMATION
System Requirements
iOS 6.1 or more
iPhone 3GS / 4 / 4S / 5 / 5S / 5C, iPad, iPod Touch 3 / 4 / 5
Androïd : V2.3.3 or more
Troubbleshooting
Difficulties
No communication
Verifiy proper network is selcted in your Smartphone settings.
Meaning of the LED on the front of the module
LED Status
Red fixed during 5 mns
Installation mode : Controller is waiting initial configuration.
Red Fixed during 2 mns
Installation Mode : Controller can be reconfigured if
needed after plugging power again
3 x red flashing
Following a power failure
to ist Wi-Fi Access point
5 x red flashing
The module is out of the installation mode after 5 minutes
without being set
Green Fixed
Run Mode
Off
No power supply
18
Solutions
Meaning
, controller had lost connexion
.
Publicité
Table des Matières
