Adjusting The Wheels; Maintenance And Cleaning; Spare Parts - Makita DT2010 Instructions De Montage

Adjusting the wheels

The wheel spacing on the guide trolley may be adjusted if
necessary. To be able to cut very closely to obstacles (e.g.
kerbstones, masonry, walls, etc.), mount the power cut with the
cutting device in the outer position (see operating instructions
for the power cut) on the guide trolley.
- Loose screws (23) of the axle Þ xing and push wheel axle
right over to the left.
- Tighten screws (23) Þ rmly.

Maintenance and cleaning

Check all screws and bolts weekly for condition and tightness.
Remove dirt with a brush or damp cloth.
CAUTION: To prevent eye injury, always wear eye protection
when cleaning the guide trolley with compressed air!

Spare parts

Reliable long-term operation, as well as the safety of your chain saw, depend among other things on the quality of the spare parts
used. Use only original MAKITA parts.
Only original spare parts and accessories guarantee the highest quality in material, dimensions, functioning and safety.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists to determine the
required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations. To Þ nd your
local distributor, please visit www.makita-outdoor.com
Please bear in mind that if parts other than original MAKITA spare parts are used, this will automatically invalidate the MAKITA
product guarantee.
Guarantee
MAKITA guarantees the highest quality and will therefore reimburse all costs for repair by replacement of damaged parts resulting
from material or production faults occurring within the guarantee period after purchase. Please note that in some countries particular
guarantee conditions may exist. If you have any questions, please contact your salesman, who is responsible for the guarantee of
the product.
Please note that we cannot accept any responsibility for damage caused by:
• Disregard of the assembly instructions.
• Use of force, improper use, misuse or accidents.
• Normal wear and tear.
• Work on the guide trolley by unskilled persons or inappropriate repairs.
• Use of unsuitable spare parts or parts which are not original MAKITA parts, insofar as they have caused the damage.
• Damage related to conditions arising from lease or rent contracts.
• Damages caused by disregarding loose outer bolted connections.
Cleaning, servicing and adjustment work is not covered by the guarantee. All repairs covered by the guarantee must be performed
by a MAKITA service centre.
schematic diagramm
(Top view)
23
23
9