Witter KA26U-FIT Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar with European facing to 94/20/EC A50-1
D 1 Right hand cleat
E 4 M12 x 40 x 1.25 Bolts, Lock Washers and 30mm O.D. Flat Washers
F 1 Safety Chain Plate
G 2 M10 x 40 x 1.5mm Bolts (10.9 Grade), Flat Washers, Lock Washers, and Special Nut Retainers with
Square Nuts
Z 1 Electrical Plate (ZEP 2)
For use with either
KA26 Flange neck option – ZF2030. Note: This towbar must be used with either a Witter Towball (part number Z11) or Class
A50-1 or A50-X towball, which dimensionally conforms to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
KA26Q Detachable neck option – ZQ2030. Please refer to ZQ fitting instructions for installation
FITTING
1. Release reamost exhaust hanger to lower exhaust, remove clips along bottom edge of bumper.
2. Assemble Special Cage Nuts as shown (PAGE 2) and insert into special holes of Cleat (D) as shown below,
Loosely attach to existing captive nuts in chassis using Bolts (E) with flat washers.
3. Insert Crossbar (A) inside lower edge of bumper and loosely secure using (Bolts (E) and Bolts (G)
4. Fully Tighen Bolts and secure exhaust and bumper.
5. Attach neck option and fit electrical plate (Z) and Safety Chain Plate (F) .
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
W0001KA26U-FIT$12090020000'Ä
W0001KA26U-FIT$12090020000
KA26U-FIT
TOWBAR
For KA26
For KIA RIO 2010-
&
KA26Q