Maintenance Instructions - Master Appliance Master Heat Gun HG-201A Mode D'emploi

Maintenance Instructions

All repairs and maintenance
recommended in this instruc-
tion manual must be per-
formed by a qualified repair
technician who is experienced
with the repair of electric tools,
a qualified service organiza-
tion, or Master Appliance
Corp.'s Repair Department.
A Master Heat Gun Main-
tenance and Repair Manual is
available upon request. Send
your request to:
Master Appliance Corp.
Attn: Repair Department
2420 - 18th Street
Racine, Wl 53403
For prompt and efficient main-
tenance and repair service,
return your product to:
Master Appliance Corp.
Attn: Repair Department
2420 - 18th Street
Racine, Wl 53403
Please enclose a note
describing your problem and
your phone number.
WARNING: Always unplug
your tool before performing
any maintenance or repairs.
Use only identical Master
Appliance brand replacement
parts.
Motor Brushes
1) Unplug tool before remov-
ing brushes.
2) Inspect brushes regularly
(at least every 100 hours of
running time). If brushes
are less than 1/8" long,
replace them immediately.
3) Remove brushes one at a
time. To remove, unscrew
the brush cap located on
the side of the housing, tip
the hole downward and let
the brush and spring fall
out.
4) Always replace brushes in
sets (2 brushes and 2
springs) to insure equal ten-
sion. If returning partially
used brushes, match the
curvature of the brushes to
the commutator.
5) To replace, drop new brush
in hole, drop in new spring
and screw on brush cap.
6) After second set of brushes
are worn down, return the
tool to a qualified repair
technician who is familiar
with the repair of electric
tools, a qualified service
organization or Master
Appliance Corp.'s Repair
Department for interior
cleaning, dressing of the
commutator, or whatever
maintenance is required.
7) Always use original Master
Appliance Corp. replace-
ment parts.
9
Lubrication
The bearings are lubricated at
the factory and require no fur-
ther lubrication.
Cleaning
Unplug heat gun before clean-
ing. To clean outside of tool,
use only a mild soap and
damp cloth. Do not use other
cleaning agents, turpentine,
gasoline, lacquer or paint thin-
ner, or other solvents that may
contain chemicals which are
harmful to plastics and other
insulating materials. Never
immerse tool in a liquid or
allow a liquid to enter inside
the tool. Make sure all vents
and openings are free and
clear of debris.