Loading Nylon Line; Troubleshooting Table - Shindaiwa T263XS Manuel D'utilisation

Loading nylon line

1. Wear Indicators

Troubleshooting table

 For spare parts and consumables, please use only genuine parts and designated products and components.
Using parts from other manufacturers or non-designated components may result in a malfunction.
Maintenance and care
1. Cut one piece of line to recommended length.
 2.4 mm dia. - 6 m
2. Align arrows on top of knob with openings in eyelets.
3. Insert one end of nylon line into an eyelet, and push line
equal distance through nylon line cutting head.
4. Hold nylon line cutting head while turning knob clockwise to
wind line onto spool until about 13 cm of each line remains
exposed.
IMPORTANT
When the wear indicators located at the bottom of the nylon
line cutting head are worn smooth, replacement of the cover or
the entire nylon line cutting head is required.
IMPORTANT
25