Replacement Parts - KRAFTWERK 506.000.080 Mode D'emploi

PROBLEM
The green LED on the smart
cable does not light when its
button is pressed.
Smart Cable LED Behavior
Green LED lit solid
Green LED flashes three times Reverse charging protection
Red LED flashes once
Red LED flashes twice
Red LED flashes four times
Red LED flashes five times
Red LED lit solid
11. SPECIFICATIONS
Weight
Product dim
Internal battery type
Ternary Lithium Battery
Battery Life
Peak Current
Cranking Current
Using Cycles
USB Output
LED Light
Full Charging Time
Charging Current
Operating Temperature Range
Storage Temperature Range

12. REPLACEMENT PARTS

Battery clamps for 506.000.080 ..............................................596.000.001
Micro USB to USB charging cable ..........................................596.000.003
USB adapter ...........................................................................596.000.004
Check connections.
If an LED is flashing, refer to the table
below. When the condition is corrected,
the smart cable will automatically reset.
Ready to jump start
Reverse polarity protection
Short circuit protection
Low voltage protection
High temperature protection
OK to press
590 g / 20.81 oz
195 x 89 x 85 mm / 7.67 x 3.50 x 3.34 in
Lithium ion polymer
8000 mAh (37 Wh)
1000 Cycles
800 PA
400 CA
25
5V DC / 2.4 A + Quick Charge 3.0™: 5V / 3A, 9V / 2A,
12V / 1.5A
1 W / 90 Lm
4~5 hours
5V DC / 2A
0°C~50°C / 0°F~122°F (Continuous Charge Temperature)
-20°C~60°C / -4°F~140°F (Continuous Discharge
Temperature)
-20°C~60°C / -4°F~140°F
• 9 •
SOLUTION
button to jump start
EN