Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• you spill something or put something on the
control panel for more than 10 seconds (a
pan, a cloth, etc.). An acoustic signal sounds
and the hob deactivates. Remove the object
or clean the control panel.
• the hob gets too hot (e.g. when a saucepan
boils dry). Let the cooking zone cool down
before you use the hob again.
• you use incorrect cookware. The symbol
comes on and the cooking zone deactivates
automatically after 2 minutes.
• you do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the hob deactivates.
The relation between the heat setting and
the time after which the hob deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
The heat setting
Touch
to increase the heat setting. Touch
to decrease the heat setting. Touch
at the same time to deactivate the cooking
zone.
Automatic Heat Up
If you activate this function you can get a
necessary heat setting in a shorter time. The
function sets the highest heat setting for some
time and then decreases to the correct heat
setting.
To activate the function the cooking
zone must be cold.
To activate the function for a cooking
zone: touch
(
touch
(
comes on). Immediately touch
until the correct heat setting comes on. After 3
seconds
comes on.
To deactivate the function: touch
www.zanussi.com
The hob deacti-
vates after
6 hours
5 hours
4 hours
1.5 hour
comes on). Immediately
.
To activate the function for a cooking
zone if there is no
then chose the highest heat setting 9 and
touch
again. Immediately touch
desired heat setting.
To deactivate the function: change the heat
setting.
Power function
This function makes more power available to the
induction cooking zones. The function can be
activated for the induction cooking zone only for
a limited period of time. After this time the
induction cooking zone automatically sets back
to the highest heat setting.
Refer to "Technical information"
chapter.
To activate the function for a cooking
zone: touch
To deactivate the function: touch
Timer
Count Down Timer
You can use this function to set how long the
cooking zone should operate for a single
cooking session.
First set the heat setting for the cooking zone
and
then set the function.
To set the cooking zone: touch
again until the indicator of a necessary cooking
zone comes on.
To activate the function or change the
time: touch
time (00 - 99 minutes). When the indicator of
the cooking zone starts to flash slowly the time
counts down.
To see the remaining time: set the cooking
zone with
starts to flash quickly. The display shows the
remaining time.
To deactivate the function: set the cooking
zone with
counts back to 00. The indicator of the cooking
zone goes out.
on the display: touch
.
comes on.
or
of the timer to set the
. The indicator of the cooking zone
and touch
. The remaining time
to set a
or
.
again and
25
Publicité
Table des Matières
