Display Settings - Kenwood KDC-268U Mode D'emploi

AUDIO SETTINGS
LPF SUBWOOFER THROUGH: All signals are sent to the subwoofer. ;
85HZ/120HZ/160HZ: Audio signals with frequencies lower than
85 Hz/120 Hz/160 Hz are sent to the subwoofer.
SUB-W PHASE REVERSE (180°)/NORMAL (0°): Selects the phase of the subwoofer
output to be in line with the speaker output for optimum performance.
(Selectable only if a setting other than [THROUGH] is selected for
[LPF SUBWOOFER].)
FADER R15 to F15 (0): Adjusts the rear and front speaker output balance.
BALANCE L15 to R15 (0): Adjusts the left and right speaker output balance.
VOLUME OFFSET For AUX: –8 to +8 (0) ; For other sources: –8 to 0: Preset the initial
volume level of each source. (Before adjustment, select the source you
want to adjust.)
SOUND RECNSTR ON: Creates realistic sound by compensating the high-frequency
(Sound components and restoring the rise-time of the waveform that are lost
reconstruction) in audio data compression. ; OFF: Cancels.
• [SUB-W LEVEL]/[SUBWOOFER SET]/[LPF SUBWOOFER]/[SUB-W PHASE] is
selectable only if [SWITCH PREOUT] is set to [SUBWOOFER] or [SUB-W]. ( 4)
• [SUB-W LEVEL]/[LPF SUBWOOFER]/[SUB-W PHASE] is selectable only if
[SUBWOOFER SET] is set to [ON]. ( 13)
14
ENGLISH

DISPLAY SETTINGS

(For )
(For / /
)
Set the dimmer
Press and hold DISP (DIMMER) to turn on or off the dimmer.
• If you have set [DIMMER TIME] ( 15), it will be canceled once you press
and hold this button.
Other settings
1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select an item ( 15), then press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow
the instructions stated on the selected item.
4 Press and hold to exit.
To return to the previous setting item, press
(For )
.