Casselin CCAP1G Notice D'utilisation page 16

USE
EN
Filling the water tank up to the mark on the side of the tray.
Turn the unit on using the main switch, rotate the position control button "0" at the desired temperature
between 30 and 110 ° C. The indicator light illuminates.
The second LED is illuminated when resistors heat up, it turns off when the desired temperature is reached.
To switch the position control knob unit to "0" and press the main switch.
Always check the water level. Never use the device without water.
After finishing use, allow to cool before emptying the water in the tank.
NOTE
The device has a security system in case of overheating. Upon activation, disconnect the device and allow it
to cool. If this protection system will start regularly, it is imperative to contact your dealer.
After automatic shutdown, the unit may be commissioned only by pressing the reset button on the unit's back
for this, wait until the temperature drops, press the Reset button.