Casselin CFRP1 Mode D'emploi page 16

Place the unit so that the plug is easily accessible to disconnect the unit if necessary.
EN
USE
The furnace is connected to the power cable.
For the ignition and during the first minutes, the used thermal insulation and grease residues cause smoke
formation and a disagreeable odor. On the first start, it is advisable to ventilate the room and operate the
oven vacuum á, á maximum power for 20-30 minutes.
To turn on the device, turn the knob (A) of the timer in the direction of clockwise and set the time desired
between 0 and 15 minutes. The orange indicator light (B) lights to indicate that power is on.
For use in continuous mode the oven, set the timer on the "manual" position by turning the knob in the
opposite direction to the needles of a watch until the mark is in the ON position.
To adjust the oven temperature, turn the thermostat knob (D) in the direction of the needles of a watch and
to program the desired temperature between 50 ° C and 300 ° C. The green light (C) goes off when the
temperature is reached. To turn off the resistors before the scheduled time, gently rotating the timer knob in
the opposite direction to Clockwise and delivered landmark position 0.
Warning: do not force this, there is a risk irreversibly damaging the timer.
Open and close the oven door using the handles.
Do not put your hands into the oven when it is on or still hot.
Use gloves and d'ustensiles indicated for this type of cuisine.
NOTE
The device has a security system in case of overheating. Upon activation, disconnect the device and allow it
to cool. If this protection system will start regularly, it is imperative to contact your dealer.
After automatic shutdown, the unit may be commissioned only by pressing the reset button on the unit's back
for this, wait until the temperature drops, press the Reset button.