A Hardware Tour - Pioneer DR-R102 Mode D'emploi

A HARDWARE TOUR

1
1 SCSI ID switch
Used to specify the SCSI ID to be assigned to the DR-R102 drive. When the drive is
to be used on the same SCSI bus as other devices (i.e., when the drive is to be
daisy-chained to other devices), different IDs must be assigned to all devices on the
same SCSI bus.
2 SCSI ports
3 SCSI termination switch
When components are connected through the SCSI connection, the terminator should
be attached to the last component in the connection. In case this drive is the last
component, set this switch to the on position.
4 Parity switch
When the parity switch is turned on odd parity checking is performed by the CD-R
drive for all data read in from the SCSI data bus, and when the parity switch is turned
off no parity checking is performed. Note that a parity bit is assigned to each byte of
output data transmitted from the CD-R drive whether the parity switch is turned on
or off.
5 Function switch label
Affix the label to the drive bay in which the CD-R drive has been inserted. (See No.6
of INSTALLING THE CD-R DRIVE on p. 9)
6
<DRC1128>
En
2
CD–R DRIVE
(when attached to changer)
3 4 5