Franke FTU PLUS 3707 I BK Manuel D'utilisation page 10

4. CONTROLS
L
Button Function
L Turns the lights on/off at maximum strength.
T1 Turns the motor on/off at speed one.
T2 Turns the Motor on at speed two.
Press and hold the button for approximately 5 seconds, with all the loads
turned off (Motor and Lights), to turn the Activated Charcoal Filter alarm
on. The relevant LED flashes twice to confirm.
To turn the alarm off, press the button again and hold for at least 5 seconds.
The relevant LED flashes once.
T3 Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads
turned off (Motor and Lights), to perform a reset. The LED S1 flashes
three times.
T4 Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system
returns automatically to the speed that was set before. If it is activated with
the motor turned off, the hood will switch to OFF at the end of the time.
Press and hold for 5 seconds to enable the remote control, indicated by
the LED flashing twice.
Press and hold for 5 seconds to disable the remote control, indicated by
the LED flashing just once.
S1 Signals the Metal Grease Filter saturation alarm, indicating that it is
necessary to wash the filters. The alarm is triggered after the Hood has
been in operation for 100 working hours.
When this is activated, it signals the Activated Charcoal Filter saturation
alarm, indicating that the filter must be changed; the Metal Grease Filters
must also be washed. The Activated Charcoal Filter saturation alarm comes
into operation after the Hood has been working for 200 hours.
5. LIGHTING
• For replacement contact technical support
("To purchase contact technical support").
10
T1 T2 T3 T4
S1
Led
-
-
-
Flashing.
-
Flashing.
-
Flashing.
Fixed.
Flashing.