Connecting Wires To Terminals - Kenwood KDC-MP245 Mode D'emploi

Connecting Wires to Terminals

AUX input (Stereo)
Use the mini-plug cable which is stereo type
and does not have any resistance.
Front side
Wiring harness
(Accessory1)
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Power control/Motor antenna control wire
(Blue/White)
Mute control wire (Brown)
Not Used (Blue)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
R
Fuse (10A)
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
P.CONT
Connect to the terminal that is grounded when either the telephone rings
MUTE
or during conversation.
⁄
To connect the Kenwood navigation system, consult your navigation
manual.
ANT.
CONT
Car fuse box
ACC
Front output
(KDC-MP245 only)
L
FM/AM antenna input
Rear output/ Sub Woofer output
Ignition key switch
Car fuse box
(Main fuse)
Battery
15
|
English