Installing The Zephyr Logo After Reversing The Door; Removing The Shelves - Zephyr PRW24C02AG-ADA Guide D'utilisation, D'entretien Et D'installation

ZEPHYRONLINE.COM
To prevent damaging the door or door gasket, make sure the door is open at least 90-degrees
when pulling shelves out of the rail compartment.
The door opens to a maximum of 135 degrees with a door stop on the bottom hinge preventing the
door from opening further.

Installing the Zephyr Logo After Reversing the Door

1. Clean the top surface of the door so the adhesive from the Zephyr logo will adhere to the door.
2. Place the logo positioning tool between the two holes on top of the door and align it.
3. Remove the film underneath the logo and place the Zephyr logo on top of the door. Press the logo
firmly, ensuring the logo adheres.
NOTE: If you do not wish to install the logo, use the (2) gray decorative nails to cover the holes on top
of the door.
Removing the Wooden Shelves
1. Open the door completely.
2. Remove all of the contents loaded on the shelf, if
applicable.
3. Pull the shelf towards yourself until it is fully extended
outward.
4. The shelf has plastic tabs on both sides indicated in the
diagram below. While facing the unit, press the plastic
tab on the right side down while pulling up on the left
plastic tab.
5. Evenly pull out the shelf from the track until it is
completely removed from the inner compartment.
PRW24C02AG-ADA Use, Care, and Installation Guide
Installation Instructions
Zephyr Logo
Logo Positioning Tool
Rail Posts
Notch
Rail
Rail
19