Demonstration Mode; Temperature Alarm; Defrosting - Zephyr PRB24C01BBSG Guide D'utilisation, D'entretien Et D'installation

Operating Your Appliance
ZEPHYRONLINE.COM

Demonstration Mode

In this mode, the compressor and fans never turn on but all other functions remain enabled. When in
Demonstration Mode, the "R" indicator light will slowly blink indicating it is in Demonstration Mode.
To enable or disable Demonstration mode, hold Power Button and tap Decrease Temperature Button
twice.

Temperature Alarm

If the interior temperature is higher than 73ºF (23ºC), "HI" is shown on the temperature control panel
and the temperature alarm will sound continuously after one hour. This indicates that the inner
temperature is too high. If the inner temperature is lower than 25ºF (-4ºC), "LO" is shown on the
temperature display panel and the temperature alarm will sound continuously after one hour. If one
of these situations occur, please reference the troubleshooting section for support.

Defrosting

The beverage cooler is designed with an automatic defrost system. However, on colder settings, some
frost may build up. Additionally, the more humid the ambient conditions, the more frost may build up.
Keep the door closed as much as possible and avoid opening the door unnecessarily to minimize frost
build-up.
If frost is preventing the door from closing properly, you may need to power the unit off until the frost
melts (possibly up to 24 hours). Use a soft absorbent towel to dry the unit.
WARNING
Never attempt to remove frost with a sharp object.
23
PRB24C01BBSG Use, Care, and Installation Guide