Wood Protection; This Must Be Considered During Installation - Weka 367.2007.16000 Notice De Montage, D'utilisation Et D'entretien

Wood protection

The product is made from natural timber, for which regular and adequate wood preservation measures are
obligatory. Please contact a wood preservation expert for information on professional preservation
measures.
Wood preservation is to be carried out by the customer at his own risk. No guarantee can be given in the
event of wood preservation not carried out in accordance with the instructions. Please also note the
provisions relating to this in our guarantee.
If you arrange to have the assembly carried out by a weka assembly team, the required applications of the
wood protection agent must be completed prior to assembly beginning.
We wish you much pleasure with your wood product.
This must be considered before installation!
Prior to assembly, find out whether you require planning permission to erect a Wooden shed.
When marking out your cabin at the planned site, pay particular attention to the location of the existing
electricity and water connections/cables.
Preparation of the substrate
Once the ground has been successfully levelled, the height and horizontal position of the foundations are to
be marked out.
Foundations
A prerequisite for assembly is an expertly laid, level and square foundation. We recommend a continuous
foundation. A foundation plan can be obtained from your specialist dealer. A raft foundation is also possible.
In order to avoid rising damp, we recommend that a barrier layer be laid between the foundation and the
floor beams using the packaging film, roofing paper or similar. Roofing paper for a barrier layer is not
included in the scope of this delivery.
To prevent damage from wind and to ensure stability, fasten the floor joists of the house to the foundation.
Suitable means for this purpose are concrete-embedded anchors or steel angle brackets and heavy-duty
anchor bolts, which can be purchased in DIY stores. Anchoring materials are not included in the scope of
delivery.

This must be considered during installation!

At least two people are required to assemble the Wooden shed.
Please drill pilot holes for all screw connections to avoid damaging the wood. The following symbol in the
instructions will indicate when this is necessary:
In order to check the right angles, measure the diagonals and make any necessary corrections until you
have the same values.
When laying the roof boarding, care should be taken to ensure that the roof boards are not pressed tightly
into each other. Subsequent swelling of the wood as a result of moisture is unavoidable.
The roofing felt provided serves primarily as a temporary protection against the weather. TO ensure lasting
protection we recommend you to cover the roof only with sanded bitumen shingles. This creates the basis for
a long life and resistance to the influences of the weather. Otherwise damage to your weka product is to be
expected.
If you have decided to cover your house with bitumen tiles, we recommend that they are laid directly
on the roof boards.
Make sure you remove the film on the bitumen strips before laying!
 Copyright HRB 366
Technische. Änderungen vorbehalten! 9 Alle Maße sind ca. Maße!