Futurelight PHS-260 Pro-Head-Spot Mode D'emploi page 55

- Main menu 3
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] or [DN] to select "ADJU".
- Lamp adjustment
With this function you can adjust the lamp via the Control Board. The shutter opens and the lamp can be
adjusted. In this mode, the device will not react to any control signal.
• Select "LADJ" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] or [DN] to select "ON" if you wish to enable this function or "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Test function of each channel
With this function you can test each channel on its (correct) function.
• Select "TEST" by pressing [UP] ] or [DN].
• Press [MODE/ENTER], the display shows"T-XX", "X" stands for the channel number.
• The current channel will be tested.
• Select the desired channel by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Wheel adjustment
With this function, you can calibrate and adjust the effect wheels to their correct positions.
• Select "WHEL" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"CODE".
• Press [MODE/ENTER], the display shows"CXXX".
• Enter the password "C050" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
• Press [MODE/ENTER], the display shows"CH-XX", "X" stands for the channel number.
• Select the desired channel by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"XXXX", "X" stands for the calibration value.
• Adjust the desired calibration value between –128 and 127 by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Main menu 4
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] or [DN] to select "TIME".
55/116 00041987.DOC, Version 1.0