Jung FMAS10UP Instructions D'utilisation page 10

eNet actionneur de commutation / à poussoir 1 voie mini
Timer behaviour, voltage re-
turn
Behaviour after the end of the
disabling function
Manual saving of the scene
values
Switch-off warning
Priority, lock-out protection
Activate lock-out protection
switching state
Deactivate lock-out protection
switching state
Priority, restraint
Activate forced operation swit-
ching state
Deactivate forced operation
switching state
Priority, wind alarm
82581233
J0082581233
Off
Restart
Basic setting: Off
On
Off
no change
Last value
Basic setting: No change
On, Off
Basic setting: On
On, Off
Basic setting: Off
0...4
Basic setting: 1
On, Off
Basic setting: Off
On, Off
Basic setting: Off
0...4
Basic setting: 2
On, Off
Basic setting: On
On, Off
Basic setting: Off
0...4
Basic setting: 3
10/12
Specifies whether the timers
for switch-on delay, switch-off
delay and run-on time remain
off after voltage return or whe-
ther they restart. Directly
connected to the parameters
"Switch-on delay", "Switch-off
delay" and "Run-on time".
Behaviour of the output when
a block is removed.
Disables the saving of the cur-
rent actuator state (On/Off) as
scene value in an actuator for
a command via a transmitter.
If the switch-off warning is ac-
tive, the light is not switched
off directly. The light goes off
30, 15 and 6 seconds before
permanent switch-off. During
the switch-off warning, a
switch-on telegram effects di-
rect switch-on. It is not pos-
sible to terminate the time
using a switch-off telegram.
Specifies the priority for recal-
ling and removing a scene of
type Lock-out protection for
the channel.
Defines the behaviour of the
output on activating the lock-
out protection.
Defines the behaviour of the
output on deactivating the
lock-out protection. Only vi-
sible when the priority for the
lock-out protection is 0.
Specifies the priority for recal-
ling and removing a scene of
type Restraint for the channel.
Defines the behaviour of the
output on activating the forced
operation.
Defines the behaviour of the
output on deactivating the for-
ced operation. Only visible
when the priority for the forced
operation is 0.
Specifies the priority for recal-
ling and removing a scene of
type Wind alarm for the chan-
nel.
24.03.2017