Important Safety Instructions - Furman PRESTIGE Série Guide De L'utilisateur

intermittent neutral) by shutting off the incoming power until the overvoltage condition is corrected and the power switch is reset.
LiFT (Linear Filtering Technology)
Furman's Linear Filtering Technology (LiFT) reduces AC line noise in an even, linear manner across a very wide bandwidth, resulting
in a lower noise floor. Traditional AC filter - conditioners have been designed for unrealistic laboratory conditions - whether multiple
pole filters or conventional series mode, prior technologies could actually harm audio and video performance more than they help,
due to the resonant peaking of their antiquated, non-linear designs. Under certain conditions, these designs can actually add more
than 10 dB of noise to the incoming AC line! Worse still, lost digital data, the need to re-boot digital pre-sets, or destroyed digital
converters are frequently caused by excessive voltage spikes and AC noise contaminating the equipment ground. Furman's LiFT
takes a different approach, ensuring optimal performance through linear filtering with no contamination, or leakage, to ground.
P-2400 AR - ADDITIONAL FEATURES:
Additionally, the P-2400 AR offers a laboratory precision dual function digital meter that displays incoming voltage in 1-volt steps
and performs as a RMS ammeter measuring current to the fifth of an amp. The voltmeter's accuracy is ±1.5 volts and features a tri-
color voltage range indicator. This informs the user whether voltage is in or out of a safe range. The ammeter accurately measures
current draw for an instant analysis of system requirements.
As mentioned previously, the P-2400 AR is equipped with fourteen regulated outlets; two front panel convenience AC outlets and
twelve rear panel outlets. The rear AC outlets feature discrete noise isolation in two banks.
The P-2400 AR's 20 amp capacity is supplied from a robust 12awg, 10 foot AC cord.
SAFETY INFORMATION
To obtain best results from your Furman P-2400 AR, please read this manual carefully before using.
WARNING
To reduce the risk of electrical shock, do not expose this equipment to rain or moisture. Dangerous high voltages are present inside
the enclosure. Do not remove the cover. Refer servicing to qualified personnel only.

IMPORTANT SAFETY INSTRUCTIONS

(Please read prior to installation)
1. Please read and observe all safety and operating instructions before installing your P-2400 AR. Retain these instructions for
future reference.
2. Your P-2400 AR should not be used near water – for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet base-
ment, or near a swimming pool.
3. Do not place your P-2400 AR near high heat sources such as radiators, heat registers, stoves, or other appliances that produce
extreme heat.
4. Your P-2400 AR should only be connected to a 120 VAC, 60Hz, grounded electrical outlet. Do not defeat the ground or change
polarization of the power plug.
5. Route the AC power cord and other cables so that they are not likely to be walked on, tripped over, or stressed. Pay particular at-
tention to the condition of the cords and cables at the plugs, and the point where they exit your Furman conditioner. To prevent risk
of fire or injury, damaged cords and cables should be replaced immediately.
6. Clean your P-2400 AR with a damp cloth only. Do not use solvents or abrasive cleaners. Never pour liquid on or into the unit.
7. Your P-2400 AR should be serviced by qualified service personnel when:
• The power supply cord or the plug has been frayed, kinked, or cut.
• Objects have fallen or liquid has spilled into the unit.
• The unit has been exposed to rain or extreme moisture.
• The unit does not appear to operate normally.
• The "Protection OK" indicator is not lit.
• The unit has been dropped, or the enclosure has been damaged.
5