Care & Maintenance; Control Panel; Air Filter - Danby DAP152BAW-I Manuel Du Propriétaire

OPERATING INSTRUCTIONS

CONTROL PANEL

1. Power button: Press to turn the air purifi er on or
off.
2. Fan button: Press to set the fan speed. Press
and hold for 3 seconds to set auto mode. In
auto mode the air purifi er will automatically
adjust the purifi cation quantity based on internal
sensors.
3. Timer button: Press repeatedly to set the timer
amount. The adjacent indicator light will show
the timer amount. The air purifi er will run for the
set amount of time and then shut off.
4. Sleep button: Press to set the sleep feature. The
sleep feature will dim the control panel lights
except for the sleep light.
5. Ionizer button: Press to set the ionizer feature.
Press and hold for 3 seconds to reset the fi lter
after cleaning.
CARE & MAINTENANCE

AIR FILTER

Unplug the appliance before removing or cleaning
the fi lter.
The fi lter can be cleaned with a brush or vacuum.
Do not use water on the fi lter as the plastic can
deform.
Press and hold the ionizer button for 3 seconds to
reset the fi lter after cleaning.
In households with pets or smokers, the fi lter may
need to be cleaned more often to remove smells.
The air fi lter should be replaced when the fi lter light
on the control panel fl ashes.
Replacement fi lters can be purchased through one
of the following methods:
• Visit www.danbyapplianceparts.com
• Visit www.danbyapplianceparts.ca
• Call consumer care at 1-800-263-2629.
NOTE: Replacement fi lters are not covered under
warranty and must be purchased separately.
Filter model number: DAP152I-F
CLEANING
• Unplug the appliance before cleaning or
servicing.
• Clean the cabinet with a lukewarm damp cloth
and neutral detergent. Dry the cabinet with a
lint-free dry cloth.
• Do not use gasoline, paint thinner or other
chemicals to clean the appliance.
• Do not wash the appliance directly under a tap
or using a hose. It may cause electrical damage.
4