Range Hood Care; Cleaning - Whirlpool LIB0098810A Instructions D'installation Et Guide D'utilisation Et D'entretien

IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
■ Liquid detergent soap and water, or all-purpose cleanser
■ Wipe with damp soft cloth or nonabrasive sponge, then
rinse with clean water and wipe dry.
Metal Grease Filter:
1. Open the stainless steel panel. Grasp panel at the left corners
and pull down to disengage the 2 catch pins from the spring
catches. The panel is attached at the right and will rotate
down.
2. Remove the filter by pulling the spring release handle and
then pulling down the filter.
A
A. Spring release handle
3. Wash metal filter as needed in dishwasher or hot detergent
solution.
4. Reinstall the filter by making sure the spring release handles
are toward the front. Insert aluminum filter into upper track.
5. Push in spring release handle.
6. Push up on metal filter and release handle to latch into place.

RANGE HOOD CARE

Cleaning

Non-Vented (recirculating) Installation Filters:
The charcoal filter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit Number
W10412939.
To replace charcoal filter:
1. Remove metal grease filter from range hood. See "Metal
2. Bend spring clips away from metal grease filter.
3. Place charcoal filter into top side of metal filter.
4. Bend spring clips back into place to secure the charcoal
5. Replace metal grease filter. See "Metal Grease Filter"
Replacing a LED Lamp
The LED lights are replaceable by a service technician only.
See the "Warranty" section for service contact information.
Grease Filter" in this section.
filter to the metal filter.
in this section.
11