Fanelite 52YFT-805 ARATIKA Mode D'emploi page 32

Speed
Press this button to adjust the speed (6 speeds, 1 is the lowest one and 6 the highest one), the selected
speed is displayed on the screen. The top arrow increases the speed, the bottom arrow decreases the
speed.
LED light (on compatible models)
Press this button to turn on the light.
Press this button to turn off the light.
Press this button to change the color temperature of the light (3000°K / 4000°K / 6000°K).
Press this button to adjust the light intensity. The top arrow increases the light intensity, the bottom arrow
reduces the light intensity.
Timer
Press this button to set the timer (automatic stop after the selected time has been reached). There are
4 possible settings, each time this button is pressed, the timer increases by one level, 1 hour, 2 hours, 4
hours, 8 hours. To deactivate the timer, press until the screen of the remote control shows 0 or manually
turn off the ceiling fan.
3/ PAIRING PROCEDURE REMOTE CONTROL / RECEIVER
By default, the remote control and the receiver are already paired together. If the remote control is not con-
nected to the receiver, please follow the steps below :
1/ Turn off the power of your ceiling fan using the circuit breaker or switch.
2/ Wait at least 30 seconds then turn on the power again.
3/ Within 30 seconds of turning on the power, press and hold the
5 seconds.
The receiver beeps when the synchronization is complete. You will then be able to use your remote control
to control your ceiling fan.
4/ PAIR THE REMOTE CONTROL ON SEVERAL CEILING FANS
When several ceiling fans (DC technology with the same remote control) are installed, it's possible to control
all of them with only one single remote control.
Repeat the above procedure PAIRING METHOD REMOTE CONTROL / RECEIVER with all the other ceiling
fans that you want to synchronize on the same remote control.
5/ CHANGE THE RUNNING DIRECTION OF THE BLADES (SUMMER / WINTER MODE)
By default your ceiling fan rotates counterclockwise (summer mode). This mode allows the room to be re-
freshed by sending the cold air down and hot air at the top. The winter mode, meanwhile, will allow you to
heat the room by sending hot air down (the blades turn in the opposite direction, clockwise).
To change the running direction of the blades, press and hold the button
5 seconds.
30
button of the remote control for around
on your remote control for about