Safety Instructions; Use - Casselin CSC3 Mode D'emploi

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

- Unpack the hair dryer completely.
- The hair dryer must be installed from the bottom of the appliance to the floor between 1.40 and 1.70m
depending on the height of the users.
- Drill two 6mm diameter holes, aligned and spaced 217mm
FLOOR AREA
- Insert the dowels into the holes.
- Screw the plastic part which clips to the hair dryer support in the wall using one of the screws provided in
the top hole.
- Then take the larger screw and screw it into the wall through the hole in the hand dryer support at the
bottom right. Secure the hair dryer support then cover the hole with the available plastic cover.
- Plug in the appliance and take the user handle.
- Take the drying nozzle, adjust the thermostat to obtain the desired temperature, (clockwise to increase
and vice versa to decrease).
- Replace the drying nozzle after use, the shutdown is automatic.
- Test it several times to verify the correct functioning of the device.
8 - Ankle
9 - Hook
10 - Screw
6 - Lid
11 - Connection
12 - Terminal
EN