Preparation And Use; Cleaning, Disinfecting And Sterilizing - Air Liquide Soffio Cube Mode D'emploi

• The basic unit (1) with power cable (2), ON/OFF switch (3), air filter slot and filter (4), air
intake (5) and nebulizer support (6).
• An accessory kit composed by: nebuliser (upper body (7), internal atomiser (8), lower body
(9)), mouthpiece (10), nosepiece (11), adult mask (12), pediatric mask (13), connecting
tube (14), connector (15)
• Replacing air filters
• Instructions for use
• Bag

2 - PREPARATION AND USE

Before use, make sure the voltage indicated on the rating plate underneath the
device corresponds to the mains voltage and the wiring system complies with the
current regulations.
Prior to using the device for the first time, we recommend cleaning it as described in the
section «Cleaning, disinfecting and sterilizing».
1. Fill the nebuliser with the inhalation solution as per your doctor's instructions (Fig.B).
Ensure that you do not exceed the maximum level.
2. Assemble the nebuliser and connect the mouthpiece or the nosepiece or the mask.
(Fig.C). Ensure that all parts are complete.
3. Connect the nebuliser with the connecting tube (14) to the compressor (1) and plug
the power cable (2) into the socket.
4. To turn on the device, push the ON/OFF switch (3) onto the position «I». Lean the
mouthpiece between the lips or the nosepiece on the nostrils or lean the mask to the
face over mouth and nose.
5. Sit in a relaxed position with the upper body upright. Breathe in and out calmly during
the therapy. Do not lie down while inha¬ling. Stop inhalation if you feel unwell.
6. After completing the inhalation period recommended by your doctor, switch the ON/
OFF switch (3) to position «O» to turn off the device and unplug it from the socket.
7. Empty the remaining medication from the nebuliser and clean the device as described
in the section «Cleaning, disinfecting and sterilizing».

3 - CLEANING, DISINFECTING AND STERILIZING

Always wash your hands well before cleaning and disinfecting the accessories.
Do not expose the compressor to water or heat.
Replace the connecting tube for each treatment with a new patient or in case of impurities.
Unplug the device before cleaning.
Cleaning
The compressor unit (1) and the connecting tube (14) should be cleaned with a clean,
moist cloth.
Clean all the nebuliser components and its accessories under warm tap water (max.
60°C) adding if necessary a small quantity of detergent following dosage and use
limitations as provided by detergent manufacturer. Rinse thoroughly making sure that
SH • ENGLISH • ENGLISH • ENGLISH • ENGLISH • ENGLISH