LEXIBOOK RP500PA Mode D'emploi page 9

WARNING: Malfunction or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur,
remove the batteries and insert them again.
- Keep a minimum distance around the device for sufficient ventilation;
- The openings should never be blocked by newspapers, curtains, tablecloths,
etc.;
- Do not place the device on open flames such as lighted candles;
- Batteries should be disposed properly. Take them to the collection container in
order to protect the environment;
- Device for use in a temperate and/or tropical climate.
Unpacking the device
When unpacking, ensure that the following elements are included:
1 x Paw Patrol Radio Alarm Clock Projector
1 x instruction manual
WARNING: All packaging materials, such as tape, plastic sheets, wire ties and
tags are not part of this product and should be discarded.
CLOCK
1. To set the clock, press and hold the MODE key until the display starts blinking.
2. Press UP/DOWN to set 12H/24H.
3. Press MODE key again.
4. Press UP/DOWN to set hour.
5. Press MODE key again.
6. Press UP/DOWN to set minutes.
7. Press MODE key to come back to the Clock Mode.
ALARM
1. To set the alarm, press MODE once. "
and hold MODE button, press UP/DOWN button to choose ON.
2. Press UP/DOWN to set hour.
3. Press MODE key again.
4. Press UP/DOWN to set minutes.
5. Press MODE key again.
6. Press UP/DOWN to set if you want to hear the radio (RAD) or the alarm (VOI).
7. If you choose the Radio, press UP/DOWN to choose the radio frequency.
8. Press MODE key to finish.
Note: The alarm lasts 1 minute.
When the alarm sounds, press RADIO key to snooze the alarm for 5 minutes (the
bell icon will flash), or press any other keys to turn it off.
RP500PAIM1158_101_V09.indd 9
Installation
Settings
" appears on the screen, then press
9
11/4/18 9:43 am