Before You Start; Packing List; Assembly - Yamabiko MTA-AHS-HD Manuel D'utilisation

Before you start

Packing list

 The following parts are packed separately in the packing box.
 When you have unpacked the box, please check the parts that it contains.
 Contact your dealer if anything is missing or broken.
1. Operation shaft
2. Blade cover
3. L-wrench

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
 Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Before you start
4. Spanner
5. Storage hook assembly
6. Operator's manual
WARNING
Power head shaft/lower shaft assembly
1. Set power head/shaft assembly on a level surface.
2. Pull locator pin (A) out, and turn anticlockwise 1/4 turn to
lockout position.
3. Remove vinyl cap from attachment drive shaft.
4. Carefully fit attachment drive shaft assembly into coupler (B)
to decal assembly line (C), making sure that the inner lower
drive shaft engages into the square upper drive shaft socket.
NOTE
Lower bearing housing and head assembly must be in line with
the power source.
5. Rotate locator pin (A) 1/4 turn clockwise to engage lower
shaft hole. Insure locator pin is fully engaged by twisting low-
er drive shaft. Locator pin should snap flush in coupler. Full
engagement will prevent further shaft rotation.
6. Secure lower shaft assembly to coupler by tightening clamp-
ing knob (D).
10