Siemens LZ51850 Mode D'emploi Et Notice De Montage page 19

Operating procedure
The most effective method of removing
vapours produced during cooking is to:
Switch the ventilator ON
as soon as you begin cooking.
Switch the ventilator OFF
a few minutes after you have finished
cooking.
Set the glass plate in cooking
position.
Light
Display for
ON / OFF
fan setting
Fan OFF
Reduce fan
speed
Acoustic signal:
When a button is pressed, this is verified
by an acoustic signal.
Switching off the acoustic signal:
Simultaneously press buttons 0 and +
until a signal is emitted after approx. 3
seconds.
Switching on the acoustic signal:
Repeat the process.
Switching the fan ON
Press the + button.
cooking position
Fan follow-
on
Fan ON and
increase speed
Intensive setting
Setting the required fan speed:
Press the + button.
The fan speed is increased by one step.
Press the – button.
The fan speed is reduced by one step.
Switching the fan OFF:
Press the 0 button.
The displayed goes out shortly
{
afterwards.
Or:
Keep pressing the – button until the fan
switches off.
The displayed goes out shortly
{
afterwards.
Intensive setting:
Maximum power is obtained at the
intensive setting. It is only required for short
intervals.
Keep pressing the + button until a
appears in the display.
If the intensive setting is not cancelled by
hand, the fan will automatically switch
back to step after 10 minutes.
}
Fan follow-on:
Press the button.
!
The fan runs for 10 minutes at setting 1.
At the same time a dot flashes in the
display.
Then the fan switches off automatically.
Lighting:
The light can be switched on at any
time, even though the fan is switched off.
Adjusting the brightness:
Hold down the button until the
a
desired brightness is obtained.
ç
19