Piercing The Wall; Sealing And Levelling The Wooden Frame; Installing The Air-Conditioner; Remove The Plastic Cover - Wine Master C18 Notice D'installation Et D'utilisation

31

2.1 PIERCING THE WALL

Cut the wall as necessary to fit the wooden frame. The outer dimension of the wooden frame is 514 mm long by
374 mm high. Be careful to leave at least 10 cm room below the ceiling, both in the cellar and outside.

2.2 SEALING AND LEVELLING THE WOODEN FRAME

Seal the wooden frame so that it is flush with the inside of the cellar wall. If the wall is thicker than the wooden frame,

2.3 INSTALLING THE AIR-CONDITIONER

2.3.1 REMOVE THE PLASTIC COVER

Unscrew the 2 screws on each side of the Winemaster
cut a wedge-shape in the wall, as shown in the diagram above.
The joint between the wooden frame and the insulation must be filled (with
polyurethane foam, for example), to ensure continuity of insulation.
WARNING, DO NOT PUT POLYURETHANE FOAM BETWEEN THE
WINEMASTER AND THE WOODEN FRAME, THE WINEMASTER MUST
BE REMOVABLE.
The wooden frame must be level :
the widest side should be horizontal
CORRECT INCORRECT
Remove the cover