Perel LEDA500W-W Série Mode D'emploi page 4

5.4 Mounting the lamp
1. This luminaire does not have a built-in device to disconnect it from the electric mains. Make sure to
electrically isolate the luminaire before installation or maintenance activities are performed.
2.
Use the mounting bracket to determine the location of the mounting holes.
3. Drill the holes and secure the bracket using screws and wall plugs.
4. Connect the power cable to the screw terminal. Make sure there is no strain on the cable; leave
sufficient slack.
Warning: if the power cable is damaged, it must be replaced by the manufacturer, his service agent, or
a similar qualified person in order to avoid any hazard.
5. To point the lamp in the desired direction: loosen the hinges using a screwdriver.
6. Tilt the lamp in the desired angle and tighten the hinges.
6. Cleaning and Maintenance
•
This luminaire does not have a built-in device to disconnect it from the electric mains. Make sure to
electrically isolate the luminaire before installation or maintenance activities are performed.
•
All screws should be tight and free of corrosion.
•
The housing, the visible parts, the mounting supports and the installation location (e.g. ceiling,
suspension, trussing) should not be deformed, modified or tampered with; e.g. do not drill extra
holes in mounting supports, do not change the location of the connections...
•
The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.
•
If the protective glass is damaged, disconnect the lamp immediately from the mains. Have it repaired
immediately by a qualified technician. Do not use the lamp with a cracked or broken protective glass.
•
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
•
There are no user-serviceable parts.
•
Contact your dealer for spare parts if necessary.
7. Technical Specifications
body colour
electrical data
power LED module
total nominal power
nominal voltage driver
power factor
energy consumption
light technical data
colour
colour temperature
beam angle
V. 02 – 21/02/2017
LEDA500xxW-x / LEDA5010NW-B
LEDA5001NW-x
neutral white
4000 K
4
N = neutral, blue
E = earth, yellow/green
L = line, brown
black/white
10 W COB
10 W
220-240 V~
0.57
10 kWh/1000 h
120°
LEDA5001WW-x
warm white
3000 K
©Velleman nv