Pan And Tilt Head; Mounting The Camera - Vinten PRO-6 HDV System Guide De L'utilisateur

English
To adjust the mid-level spreader:
There are two spread settings. To select maximum (flat) spread, lift the spreader centre moulding
such that lugs can pass the extension arms, and rotate the spread knob (28) fully clockwise. To
select minimum (45°) spread, lift the spreader centre moulding and rotate the spread knob (28) fully
anticlockwise.
NOTE: The spread knob (28) will not rotate when the spreader is loaded. Lift the spreader
centre moulding to allow the knob (28) to rotate freely.
A pointer on the knob (28) indicates maximum or minimum spread setting.
Extension arms can be individually adjusted by releasing the extension clamps (29), extending the
arm as required and re-tightening the clamp (29).
NOTE: Do NOT attempt to fold the tripod if the spreader extension arms are uneven lengths.
Set all extension arms to the same length (29) and then fold the tripod.
To adjust the tripod:
Adjust the operating height by undoing the leg clamps (21) and pulling the tripod up to the desired
height. Adjust the spreader (29) if necessary.
Tighten the clamps (21) until an audible click is heard and the knob is in the horizontal, locked po-
sition.
In adverse conditions secure the tripod using the tie-down hook (27), or suspend a weight from the
hook.
WARNING! Use care when the tripod is fully extended and the floor spreader is in the
closed position, as stability will be reduced.

Pan and tilt head

(Fig 1)
HDV
The PRO-6 pan and tilt head is supplied with a 75 mm ball mount. Adaptors are available which enable
the head to be installed on tripods or pedestals fitted with other mountings. These are listed under 'Optional
Accessories'.
To install the head, remove the bowl clamp assembly (10) from the head, position the head on the tripod
and refit the bowl clamp assembly from below. Level the head with the aid of the level bubble (11) and tight-
en the bowl clamp (10). The level bubble may be illuminated by pressing the switch (13). The light will ex-
tinguish after approximately 15 seconds.
NOTE: After unpacking the product, to initially illuminate the level bubble, a paper
transportation tab must be removed from the battery. To access the battery, see 'Battery
replacement' on page 16.

Mounting the camera

(Fig 1) (Fig 4)
Remove the slide plate (17) from the head by releasing the slide plate clamp (2), pressing the slide lock
release (1) and lifting the plate upward.
Install the required camera fixing screw (6) or (19) in the slide plate and retain with the rubber bung (18).
Stow the unused screw in the appropriate stowage (7) in the platform.
12