Publicité
Les langues disponibles
Les langues disponibles
SAFETY RULES
1. Connect battery chargers that are used in the
open via a ground fault circuit breaker.
2. Keep the battery charger away from rain or
moisture. Penetration of water in the battery charger
increases the risk of an electric shock.
3. Do not charge other batteries. The battery charger
is suitable only for charging HAUSSMANN Ni-Cd batteries
within the listed voltage range. Otherwise there is danger
of fire and explosion.
4. Only charge the battery at an ambient temperature
0
0
between 0
C (32
F) and 45
service life is achieved in this manner.
5. Keep the battery charger clean. Contamination can
lead to danger of an electric shock.
6. Before each use, check the battery charger, cable
and plug. If damage is detected, do not use the
battery. Never open the battery charger yourself.
Have repairs performed only by a qualified
technician and only using original spare parts.
Damaged battery chargers, cables and plugs increase
the risk of an electric shock.
7. Do not operate the battery charger on easily
flammable surfaces(for example, paper, textiles, etc.)
or surroundings. The heating of the battery charger
during the charging process can pose a fire hazard.
KNOW YOUR PRODUCT
Read all safety warnings and all instructions. Failure
to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
1
3
2
0
0
C (113
F). A long battery
4
The numbering of the product features refers to the
illustration of the tool below:
1.
Battery pack
2.
Battery charger
3.
Red light
4.
Green light
TECHNICAL DATA
Batt
1
1
ery
4
8
Batt
ery
A
Inpu
C
t
Out
put
Cur
rent
Ch
0
0
0 C(32 F) ~45 C(113 F) 0 C(32 F) ~45 C(113 F)
arg
ing
Batt
ery
Cha
rgin
Prot
ecti
1. Charging the battery
The battery is partial charged when purchased and must
be charged fully before operation. New batteries, or a
battery that has been stored for some time, may not
initially accept a full charge. This is normal. It will charge
fully after several charge and discharge cycles. The first
charge of a battery pack will take up to 1hour. Subsequent
full charges will also take up to 1 hour. The batteries
should be charged at an ambient air temperature of
0
0
between 0
C (32
F) and 45
To charge a 14.4V/18V NiCd battery pack,proceed
as follows:
1. Connect the charger to the mains supply and switch on.
The green light will turn on. The red light is off.
2. When the battery pack is inserted into the charger,the
red light will flash(frequency=1Hz). The green light
remains on.
3. When the battery is fully charged,both the green and
red lights will remain fully lit.
4. In the event of a charging failure,the red light will
flash(frequency>2Hz).The green light remains on.
2. Remove the battery
When the battery is fully charged, please remove the
battery pack from the battery charger. Do not leave the
battery in the charger when the charger is plugged in.
4
OPERATION
0
0
C (113
F).
Publicité
