Symbols Used; Safety Instructions - Polar Bear BRC Série Mode D'emploi

SYMBOLS USED

SYMBOL MEANING
DANGER
IMPORTANT WARNING
LIVE COMPONENTS RISK OF ELECTRIC SHOCK
MOVING PARTS
HOT SURFACE
SHARP SURFACES

SAFETY INSTRUCTIONS

• READ THE INSTRUCTION MANUAL CAREFULLY BEFORE CARRYING OUT ANY WORK ON THE EQUIPMENT.
• The unite is factory precharged with dry nitrogen or with dry air to prevent the ingress of any water vapour. Before removing
the plugs from the inlet and outlet connections for installation, discharge the nitrogen by means of the needle valve on the
inlet manifold
• The condenser contains gas above atmospheric pressure: tampering with connections or pipework can cause leakage of
compressed gas
• The temperature of the inlet pipe to the condenser can rise above 70°C and therefore presents the risk of burns
• All work must be performed, components selected and materials used professionally and in complete accordance with the
legislation in force in material in the country concerned, and considering the operating conditions and intended uses of the
system, by qualified personnel.
• INSTALL THE CONDENSER IN A POSITION WHICH IS INACCESSIBLE TO UNAUTHORISED PERSONNEL: the fins
of the heat exchanger are made from thin aluminium sheet and can cause cuts in the event of accidental contact.
• The unite contains live electrical parts and rotating devices: before carrying out any work on the electrics or on
the fan, isolate the unit (turn optional isolator to position 'O')
• All service and maintenance operations which require access to the inside of the unit while it is in operation must
be performed by qualified and experienced personnel who are aware of the precautions which must be taken.
• In the event of fire, water and other conductive substances must not be used to put out the fire near live electrical compo-
nents. This warning must be displayed on notices in the unit installation location.
• If the refrigerants used come into contact with fire they decompose, forming acids and other irritants.
The smell of these substances, even at concentrations below danger levels, gives enough warning to allow evacuation of
the area at risk.
Make sure that the power supply voltage corresponds to the value shown on the data plate.
BRC / BRE / i-BRE / BDC / i-BDC EN
21