Vestfrost W32 Mode D'emploi page 5

Installation
The surface on which the appliance is to be
placed must be level. Do not use a frame
or similar. It is important that the appliance
be absolutely level. It can be levelled by
screwing the adjustable feet at the front of
the appliance up or down (fig. 2).
Use a spirit level to check that the appliance
is absolutely level sideways.
Build-in
W32 is only for free-standing, and suffi-
cient free air around the appliance must be
ensured. (fig. 4)
The appliances W45 and W38 can be
installed as built-in units in kitchen elements
or be placed free-standing (fig. 3).
At built-in condition ensure sufficient airflow
through the kitchen base in front of the
appliance. The total cross section of the
opening must be as described in fig. 3, and
individual air duct clearance must be at
least 5 mm.
Along with your new cabinet is a replace-
able kick plate which can be fixed with the
two screws. These two screws are located
in the accessories bag, see figure 2_1
If needed there is a kit in the accessories
bag, see figure 2_1, for fixing the cabinet up
against a table top.
fig. 3
fig. 3
5
GB
fig. 2
fig. 2
fig. 2_1
fig. 4
fig. 4