Speed Control; Maintenance; Transport And Storage - jcb 18BLDD Instructions D'utilisation

Press the bit firmly against the screw and
m
drive in the screw.
Once the screw is sufficiently tightened,
m
release the power switch before you stop
pressing in the screw, otherwise you can
damage the screw or screw head. The
bit or tool can be damaged if you do not
release the power switch immediately.
To unscrew/loosen screws:
Set the rotation selector to anticlockwise
m
rotation.
Place the bit into the screw head in line with
m
the screw. Otherwise the screw can be
damaged.
Press the bit firmly against the screw and
m
loosen the screw.

Speed Control

WARNING!
Only use the speed control switch when the
tool is stopped and the chuck is not rotating.
Otherwise the tool can be damaged.
Move the speed control switch away from
m
the chuck to position 1 for low speed (0 to
500rpm).
Use the low speed mode for screw driving
m
and for drilling holes with a large diameter.
Move the speed control forwards towards
m
the chuck to position 2 for high speed (0 to
1800 rpm).
Use the high speed mode for drilling small
m
holes.
16

Maintenance

WARNING!
Switch off the tool and disconnect the power
(remove battery/unplug) before cleaning and
maintenance. This helps avoid the risk of
electric shocks and accidental starting.
Wipe the tool with a dry or damp cloth.
m
Do not use a wet cloth. Do not use
detergent that contains solvent or
corrosive, abrasive additives. This risks
damaging the surfaces of the tool.
Clear the tool vents and the accessory
m
mount of dust and dirt after each use.
Do not clean ventilation holes by
inserting sharp objects in them, such
as screwdrivers and other similar
objects.
Stubborn contamination in areas hard to
m
access can be removed with compressed air
(max 3. bar).
Regularly check all fasteners, screws and
m
bolts to make sure that they are tight.
Tighten any loose screws immediately or
serious injury could occur.
WARNING!
Never open the tool. The tool has no
internal parts that the user can service or
repair. Never try to repair the tool yourself.
Take to an authorised service centre.

Transport and Storage

If the tool will remain unused for any length
m
of time, it should be stored in the original
packaging.
Store the tool in a dry, frost-free, well
m
ventilated place.
Instruction & User Manual
JCB-18BLDD