Vibration Information - jcb 18BLRH Instructions D'utilisation

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined according to EN 60745-1 and
EN 60745-2-6
Drilling into
Concrete
Chiseling
Uncertainty (K)
WARNING!
The vibration emission value of the power
tool is tested under EN 60745-1 and EN
60745-2-6, and can vary during operation
depending on the following usage conditions:
How the tool is used and the materials
m
being cut or drilled.
The tool being in good condition and well
m
maintained.
Using the correct accessory for the tool and
m
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and
m
if any anti-vibration accessories are used.
The tool being used as intended by its
m
design and these instructions.
The declared vibration total value may also
m
be used in a preliminary assessment of
exposure.
THIS TOOL MAY CAUSE HAND-ARM
VIBRATION SYNDROME IF USAGE IS
NOT ADEQUATELY MANAGED.
12
Main Handle
Auxillary Handle
Main Handle
Auxillary Handle
8.361 ms
-2
7.806 ms
-2
11.004 ms
-2
7.742 ms
-2
1.5 ms
-2
WARNING!
To be accurate, an estimation of exposure
level in the actual conditions of use should
also take account of all parts of the operating
cycle. These include times when the tool is
switched off and when it is running idle but
not actually doing work. This may significantly
reduce the total exposure level over the
working period, helping to minimize your
vibration exposure risk.
ALWAYS use sharp and undamaged bits,
m
chisels, drills and blades.
Maintain this tool in accordance with these
m
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest
m
in anti-vibration accessories.
Avoid using tools in temperatures of 10
m
or less.
Plan your work schedule to spread any high
m
vibration tool use across a number of days.
Instruction & User Manual
C
°
JCB-18BLRH