Front Panel; Rear Panel - Rane MLM82S Guide D'utilisation

Features

Front Panel

1
1. Signal/Overload LED: This LED illuminates green when a signal of at least -30 dBu is
received, and turns red when the signal is within 3 dB of clipping. If the Overload LED
illuminates, turn down the input signal to prevent the signal from distorting.
2. Mono Input Level: Adjust this knob to control the level of each mono channel.
3. Assign Switches: Adjust these switches to route the signal for each Mic/Line input to the A,
A+B, or B outputs.
4. Stereo Line Input Level: Adjust this knob to control the amount of the stereo input signal routed
to the outputs.
5. Mono Switch: Adjust this switch to control the mix for the A and B sides of each stereo line
input together. When active, the associated LED lights and the A and B inputs for that channel
will have the same level.
6. Output Overload LED: This LED illuminates when within 3 dB of clipping. To avoid this, the
output level control can be decreased, or the individual input level can be lowered.
7. A and B Output Level Controls: Adjust these knobs to set the output level for the A and B
outputs.
8. Power LED: This LED is lit whenever adequate power is applied to the unit.

Rear Panel

6
1. Mic/Line Inputs 1-4: Connect microphones or line-level devices to these balanced XLR inputs.
2. Phantom Power Switch: Adjust this switch to apply 15V phantom power to any of the inputs
1-4 that are set for mic-level.
3. Line Input Selectors: Adjust this to switch the sensitivity and input impedance for either mic or
line-level input. If Line is chosen, phantom power is deactivated for that input.
4. 1/4" Line Inputs: These stereo pairs of balanced inputs accommodate stereo line-level signals.
These TRS (Tip-Ring-Sleeve) 1/4" jacks handle either balanced or unbalanced signals. In most
cases, an unbalanced signal may use a mono 1/4" plug (Tip-Sleeve).
5. A and B Outputs: These balanced XLR's provide the A and B mixed output. The internal output
level switches allow setting the output level for mic or line-level.
6. Power Connector: Connect the included power cable here.
6
2
3
5
4
3
4
7
5
6
1
8
2