Routine Maintenance Performed By Qualified Technicians; Gaskets; Connection To The Flue; Calculation Of The Thermal Power - LA NORDICA PADOVA Manuel Utilisateur

ROUTINE MAINTENANCE PERfORMED BY QUALIfIED TECHNICIANs

Routine maintenance must be performed at least once a year.
Using wood as solid fuel, the generator requires annual routine maintenance, which must be performed by a qualified technician, using
only original spare parts.
Failure to comply can jeopardise the safety of the appliance and make the warranty null and void.
Respecting the frequencies of cleaning reserved for the user described in the use and maintenance manual, the generator is guaranteed
correct combustion over time, preventing any anomalies and/or malfunctioning that could require more interventions of the technician.
Requests for routine maintenance are not contemplated in the product warranty.

gAskETs

The gaskets guarantee the tightness of the stove and its consequent good functioning.
They must be controlled periodically. They must be replaced immediately if they are worn or damaged.
These operations must be carried out by a qualified technician.

CONNECTION TO THE fLUE

Vacuum and clean the pipe that leads to the flue yearly or any time that it is necessary. If there are horizontal tracts, the residue must be
removed before it can prevent the passage of the fumes.

CALCULATION Of THE THERMAL POWER

There is not an absolute rule for calculating the correct necessary power. This power is given according to the space to be heated, but it
depends also largely on the insulation. On an average, the calorific value necessary for a properly insulated room is 30 kcal/h per m
external temperature of 0°C).
Given that 1 kW corresponds to 860 kcal/h, it is possible to adopt a value of 35 W/m
Let's suppose one wishes to heat a room of 150 m
W/m = 5250 W or 5,25 kW. As main heating, a 8 kW device is therefore sufficient.
3
fuel
Dry wood (15% humidity)
Wet wood (50% humidity)
Wood briquettes
Brown coal briquettes
Normal anthracite
Coke
Natural gas
Naphtha
Electricity

TROUBLEsHOOTINg

PROBLEM POSSIBLE CAUSES
The frame of
the cooker or
™ Flue draught pressure too high
its parts change
colour
Bended oven and
™ Flue draught pressure too high
chipped enamel
™ A slight coat of rust on the whole
Rust on the
surface of the cooking plate
stainless steel
may depend on wet air (cooking
cooking plate
steam)
34
(10 x 6 x 2.5 m) in an insulated apartment. In this case, it is necessary to have 150 m
3
Approximate combustion value
Unit kcal/h
kg 3600
kg 1850
kg 4000
kg 4800
kg 7700
kg 6780
m 7800
3
L 8500
kW/h 860
POSSIBLE SOLUTIONS
™ Clean the surfaces;
™ Contact the chimney sweep for a possible installation of a throttle
valve;
™ Small enamel chips do not compromise the correct functioning of the
appliance. In case of major damages contact the Customer Service.
™ Contact the chimney sweep for a possible installation of a throttle
valve
™ Grind the surface;
™ Only when the plate is cold, grease the surface with non acid grease
(vaseline or paraffin oil);
™ Only when the plate is lukewarm, clean with a soft cloth
ENgLIsH
.
3
Required quantity in relation to
1 kg of dry wood
kW
4.2
2.2
5.0
5.6
8.9
7.9
9.1
9.9
1.0
3 (for an
x 35
3
1,00
1,95
0,84
0,75
0,47
0,53
0,46
0,42
4,19