t.a.c. V-88 Manuel D'utilisation page 28

1. POWER
This is the main power switch for turning on and
off the device. The amplifier is separated from the
mains voltage when switched off and cannot be
set into a standby state.
2. WARM UP
This LED illuminates during the warm up shortly
after switching on the appliance.
3. LEDs displaying the input
channel selection
Depending on what input channel has been selec-
ted (6)(13), one of these LEDs is lit. Additionally
these LEDs show that the appliance is switched on.
28
tube·amp·company
FRONT VIEW
1 2
4
3
4. VOLUME /
This is the knob for the adjustment of the main
volume level of the system.
5. Infrared receiver for the remote control
6. INPUT: Input Selector
This dial allows you to choose one of the four
inputs. The LED (3) that is actually lit shows you
what input channel has been selected.
5 6
: Volume dial