Panasonic Lumix DMW-MCTZ30 Manuel D'utilisation page 11

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
2
Check the O-ring.
Check that there is no dirt, sand, hair, dust, salt crystals, lint or grease on the
O-ring. If you find any of these, remove them with a soft, dry cloth.
3Dirt
There may be dirt on the O-ring that you cannot see. Check if there is any dirt by
rubbing your finger over the O-ring.
Be careful not to leave any fibers from the dry cloth on the O-ring when wiping it.
Check that the O-ring is not ripped, twisted, squashed, frayed or scratched and
that there is no sand sticking to it. Replace the O-ring in these cases.
3Ripped
3
Inspect the O-ring groove.
Grains of sand or hardened salt crystals may get into the O-ring groove.
Remove them carefully with an air spray or a cotton swab. If you use a cotton
swab, be careful not to leave any fibers from it in the O-ring groove.
Inspect the front case groove as well as the rear case (side where O-ring is set)
groove.
3Sand
3Hair
3Twisted
3Squashed
3Dust
3Salt
crystals
3Frayed
3Scratched
3Lint
3Sand
11
VQT4C30

Publicité

Table des Matières
loading

Table des Matières