Broncolor RFS 2.2 Mode D'emploi page 9

3. SETTING STUDIO ADDRESSES
The transceiver must have the same studio address as the flash units used.
First set the studio address you want to use on the flash units, and then syn-
chronise the RFS 2.2 transmitter.
To set the studio address (studio channel), please proceed as follows:
1) Press the " ST " key for longer to enter the studio channel menu.
2) Set the studio address with the scrolling wheel as required (01 to 99).
3) Save the setting with a short press on the " ST " key. The transceiver syn-
chronises with the flash units.
9