Weelko WKM011 Mode D'emploi page 5

CONTENT
On arrival of the package, check the pre-
sence of the following items:
-UV-LED nail dryer
INSTALLATION AND
OPERATION
1. Plug the device into a wall socket
and place it on a flat and ventilated sur-
face.
2. Turn the switch on.
3. Place the patient's hands below
the device and the light will turn on.
4. The 99-second digital timer will
automatically be activated. The device
will automatically switch off after this
time
5. The UV-LED fluorescent lamps of
the nail drier help dry the nail polish and
give a better finishing of manicure and
pedicure. Suitable for permanent and se-
mi-permanent nail polish and gel nails.
EN
CAUTIONS
1. Hands must be placed correctly to
be detected by the sensors and to turn
the UV-LED lamps on.
2. Do not use this device to dry in-
flammable products, such as nail polish
removers.
3. Turn the device off after each use
and unplug it from the wall socket.
4. Keep the power cord away from
fire or potential danger zones.
5. Keep the device out of reach of
children to avoid accidents or injuries.
Store the device correctly after each use.
6. If the device is not working proper-
ly, do not use it and contact your distri-
butor.
MAINTENANCE
• Clean the device with a soft dry
cloth. Do not use damp cloths to avoid
damaging the surface of the device.
TECHNICAL DATA
VOLTAGE
FREQUENCY
RATED POWER
DIMENSIONS
Nº of UV-LED
220VAC-240VAC
50HZ/60HZ
24 W
20X12X8 CM
15
© 2020 Weelko
www.weelko.com
Importer: Weelko Barcelona, S.L.
ESB65397556