Publicité
Les langues disponibles
Les langues disponibles
Signature PRE
Using your YBA Remote Control
Note: PRESS means a short press on a key while HOLD means to keep the key pressed for more than 3
seconds. Always point the remote towards the IR window of your MP100
0 0
1
2
2
3
4
12
5
6
11
CAUTION
Before connecting any input or output.....
Always make sure your Signature PRE is in the OFF position. If you have any doubt, unplug the AC power cable
from the wall.
Make sure any components connected to your Signature PRE are off.
Neatly arrange and organize wiring to and from your Signature PRE and to and from all your components.
Separate AC wires from audio cables to prevent hum or other unwanted noise from being introduced into the
system.
Page 6
Select the device you want to control between AMP, CD and AUX. To
0
control the Signature PRE, you need to select AMP button.
1
Press AMP to turn on your pre-amplifier.
Hold (> 3 seconds) AMP button to turn off your pre-amplifier.
Note: AMP will remain the active function until you press another
device.
1
SOURCE+/SOURCE: Press SOURCE+/SOURCE to skip to the desired
source.
VOLUME+/VOLUME: Press VOLUME+ to increase the volume or
2
VOLUME- to decrease the volume. This is a universal control and
does not require specific source selection.
VIEW: Hold (>3 seconds) to switch ON/OFF the display (dimmer).
3
4
FCT: Hold (>3 seconds) to hold the current volume level.
5
AUDIO: Press to resume the stored volume level.
6
MUTE: Press to mute. Press again to exit mute. You can also
control the phase from this button. HOLD (>3 seconds) for PHASE
switching. When the PHASE LED is on (amber) the pre-amplifier
generates a 180 degree phase shift between the input and output
signals. When the LED is off, this does not occur.
www.ybahifi.com
Publicité
