Protectors For Normal Roller-Skating; How To Put On The Knee And Elbow Pads - Crivit Sports IAN 93709 Instructions D'emploi

Congratulations!
With your purchase you have decided on a high-quality product. Get to
know the product before you start to use it. Carefully read the following
operating instructions. Use the product only as described and only for the
given areas of application. Keep these instructions safe. When passing the
product on to a third party, always make sure that the documentation is
included.

Protectors for normal roller-skating

The European standard EN 14120 defines two protector
performance classes: level 1: protectors for normal roller sports
and level 2: protectors for acrobatic roller sports. You have decided on
performance level 1 protectors.
Knee pads, elbow pads, palm/hand pads and helmet are part of the
complete outfit.
Even the best equipment does not give total protection. The risk can be
minimised but injuries are always possible as experienced skaters know
only too well. Therefore always skate carefully and within your limits. You
should preferably attend a skater training school. There you can learn skat-
ing technique, which includes how to "fall correctly".
Please note that the efficiency of the protectors can be reduced when
subjected to high or low temperatures.
To obtain the best possible protection, first select the right size of protec-
tors. Try them on to check how they match your knee, arm and hand size.
The protectors may not fit too loosely. They should be snug and difficult to
move back and forth or out of position.

How to put on the knee and elbow pads

1. First open the hook & loop
fastenings.
2. Now put the guards on. Please
make sure that your knees or
elbows are completely covered
by the plastic caps. Pull the
"stocking" over your arm or
your leg.
GB 23