Atlantic SOLW2 Manuel D'utilisation page 2

Introduction
Thank you for purchasing Atlantic SOL Lighting. Atlantic's SOL lighting features
solid brass bodies with an oil-rubbed bronze finish. These lights work under water
and in open air applications to give your water feature a soothing, warming glow
after the sun goes down. Multiple LEDs can be connected to be run through
one transformer.
Prior to Operation and Installation
Caution:
• DO NOT operate this product under any condition other than those for which it
is specified. Failure to observe these precautions can lead to electrical shock,
product failure, or other problems.
• Follow all aspects of electrical codes when installing SOL Lighting.
• To reduce the risk of electrical shock, connect only to a 110 volt receptacle
protected by a ground fault circuit interrupter (GFCI).
• The input power to the Driver is 12 volt AC. The driver is located approximately
5' from the end of the cord, and is labeled "DO NOT REMOVE". The Driver
can be connected to a larger outdoor lighting transformer; however this must
be done on the 12 volt AC input side of Driver. Removing the Driver or
tampering with the cord between the Driver and the light fixture will damage
the LEDs and void warranty.
Installation
Fixture Installation
SOL Spotlights offer three different mounting options for your convenience:
• Adjustable stand: for placement on rock ledges, under waterfalls or for
highlighting streambeds
• Ground stake: for installation around the perimeter of the water feature or
in conventional landscape installations
• Nested: without the stand or stake, amongst the pond stones
SOL Light Ring is ideal for illuminating fountains and up lighting waterfalls.
• Proper light placement is important for every project. Whenever possible lights
should be positioned facing away from the viewing area to minimize hot spots.
• When camouflaging the light cord with rocks and gravel, always leave enough
slack in the cord so that the fixture can be raised above water level for servicing.
• Always verify that the lens cover is tightly secured before submersing the fixture
• Never cut or shorten the light cord between the Control Module and the light
fixture. Altering the light cord will damage the LEDs and void warranty.
2