Fastening The Converter To A Flat Surface; Connecting Converter Cables - Schumacher Electric XI75B Guide D'utilisation

4. FASTENING THE CONVERTER TO A FLAT SURFACE

For convenience, your converter can be fastened to a flat surface, horizontally
or vertically. The area where the converter is to be fastened must be dry, well
ventilated and away from any combustible material or fumes.
1. Turn off and disconnect the converter.
2. Place the back of the converter with the mounting bracket against a secure and
flat surface.
3. Attach the converter to the flat surface using corrosion-resistant screws.

5. CONNECTING CONVERTER CABLES

The converter and power source must be in the OFF mode.
IMPORTANT: Make sure to connect your converter only to a 12 volt power supply.
CONVERTER CONNECTION:
1. Locate the positive and negative plastic terminals on the right side of the
converter and remove the terminal caps completely.
2. Install the positive (red) cable ring lug onto the positive (red) terminal screw.
Install the negative (black) cable ring lug onto the negative (black) terminal
screw. Tighten each terminal so that the cable cannot come loose.
CONNECTING CONVERTER CABLE TO A VEHICLE (100 watts maximum):
1. Remove the cigarette lighter from its outlet (if applicable).
2. Push the 12 volt power plug firmly into the outlet.
CONNECTING CONVERTER CABLES TO 12V BATTERY
OR 12V POWER SOURCE:
1. Keep hands, hair, clothing and jewelry clear of battery terminals.
2. Wear eye protection and clothing protection.
3. Connect the positive (red) converter terminal cable to the power source
positive (+) or battery terminal. Make sure the connection is secure.
4. Connect the negative (black) converter terminal cable to the power source
negative (-) or battery terminal. Make sure the connection is secure.
5. To disconnect the converter, reverse the above steps.
NOTE: The internal speaker may make a brief "beep" when the converter is being
connected to or disconnected from the 12 volt power source.
CAUTION: Failure to make the correct connections will result in blown fuses and
permanent damage to the converter.
• 6 •