Installation - Indel Webasto Marine isotherm CR36 Instructions Pour L'installation Et L'utilisation

User Manual

4.1 Installation

Isotherm refrigerators have been designed and constructed exclusively for recessed
installation and installation that is in compliance with standard dimensions. The
refrigerator must always be in a horizontal position, with the compressor's rubber
feet at the bottom. The compressor is capable of functioning at angles of up to 30°.
The compressor can become damaged with any higher inclinations.
In the CR42 model, the compressor is installed on a removable corner plate and
comes supplied with extra tubing made from a particularly flexible material, so it can
be set for remote operation up to nearly 1.5m from the refrigerator. The tubing must
be carefully arranged so that it does not get pinched or broken at the curves.
Also remote operation compressors must be installed with its rubber feet downward.
Mounting flanges are available as an accessory in order to simplify the refrigerator's
installation (for models that don't come supplied with a standard fastening flange).
The refrigerator must always remain resting upon its rubber support feet, and must
be fixed in place by the mounting flanges.
Elegance models can be fixed to the lodgings by means of the Easy Fix system. This
system involves four special pre-drilled points inside a trunk, for easy and effective
installation that is not visible from the outside (Fig. 12).
With Easy Fix, you can install Cruise Elegance units with the door flush to the
furniture without using a special mounting flange. For this installation, you must
leave 10 mm of space between the refrigerator and the furniture unit at least for the
entire thickness of the door, thus ensuring its free movement (Fig. 11).
When it is not possible to use the mounting flange, secure the refrigerator in such
a way so that it will not tip/slide forward when the drawer is opened or in the case
of sudden vehicle movement. The unit should be anchored by at least 2 fastening
points, in accordance with the provisions of the EN 60335-2-24 standard.
47