Details On The Device; Signal Tones; Overheating Protection Facility; Rating Plate - Ellrona Ergo 3400 Mode D'emploi

14.1.1

Details on the device

14.1.2

Signal Tones

14.1.3

Overheating Protection Facility

14.1.4

Rating plate

Ellrona Ergo 3400
This instruction, is to warn that the ceramic hob may still be hot.
Although the induction cooker itself does not generate any heat
during the cooking process, the temperature of the cooking
utensil does heat the hot plate!
Adhere to the following safety instructions in order to avoid
being burnt by the hot appliance:
Risk of burning due to hot surface!
Do not touch the surface of the ceramic hob while it is still
hot .
Do not place any objects on the hot ceramic hob.
The appliance emits an acoustic signal after being switched on
and in the event of a fault.
The acoustic signal continues to sound until the fault has
been rectified or the appliance has been switched off.
You will find more detailed information on error messages in the
chapter entitled „7.2 Error Messages".
The appliance is equipped with an overheating protection
facility. If the temperature of the appliance exceeds the critical
limit the appropriate error message is displayed and an acoustic
signal sounds. For safety reasons the appliance shuts off
further power supply. After the cooling-down phase the
appliance can be switched off and then back on again.
The acoustic signal continues until the fault has been
rectified or the appliance has been switched off.
You will find more detailed information on error messages in the
chapter entitled „7.2 Error Messages".
The rating plate with the connection and performance data can
be founded on the back of the device.
Operation and Handling
ATTENTION
Please note
52