Switching Off - WIKA GFU08 Mode D'emploi

7. Display unit
Step Display
6
hirES
or
LEGAL
7

7.2.1 Switching off

Keep the C button pressed until the message "-off-" is shown in the display.
In order to the switch the display unit off and then on again, keep the C button pressed
for 8 seconds. The display unit switches off and then automatically switches back on.
7.3 Zeroing the scales
If the gross weight lies within ± 2 % of the nominal load, it is possible to set the display
unit to zero by pressing the ZERO button. The display no longer indicates any weight
and the power-on lamp lights up, and symbols are shown on the display.
7.4 Function of the MODE button
Operating But-
modes ton
STANDARD MODE
NET/GROSS MODE
SETPOINT ENTER
IN/OUT MODE
ALIBI MEMORY MODE
TOLERANCE MODE
CHECK
ENTER
PERCENT MODE
WIKA operating instructions SF
Description
Non-calibratable display unit.
Calibratable display unit.
Display unit performs countdown for self-checking.
Effect Button Effect
Change units
between kg and lb
Switching between
gross and net
weight
With model GFU-08
SF gas filling cart,
6
without function
Input weight
Input of recall
number
Input of target
weight
Input of plus
tolerance weight
Input of % value
gas filling cart, model GFU08
6
ENTER Output weight
ENTER Input of ID number
ENTER Input of minus
tolerance weight
ENTER Input of minimum
weight
ENTER MODE button:
a) Changes % to
weight
MODE button 2 sec.:
b) Piece
EN
Button
ENTER
>>>>>
ENTER
27